电话：+86 ( 20 ) 3205 2002
传真：+86 ( 20 ) 3205 2003
Gas cooling spraying solution
In the hazardous waste incineration system, the dumped hazardous waste is mixed uniformly by the overall rotation of the furnace and moves in an inclined direction towards the discharge end. The furnace is equipped with a secondary combustion chamber, where the waste is decomposed and gasified in the rotary kiln to produce combustible gases, which are completely burned in the secondary combustion chamber.
The 100°- 800° high temperature flue gas from the waste heat boiler is reduced to less than 200° or lower in the rapid cooling tower. After passing through the atomizing lance, the cooling water is atomized into fine particles which are in full contact with the high temperature flue gas for heat exchange and evaporate in a short time to quickly take away the heat, causing the flue gas temperature to drop rapidly and preventing the re-generation of dioxins at 500°-300°.
The three-stage atomization principle of the AirMin lance makes it possible to achieve ultra-fine atomization, which is in full contact with the high temperature flue gas, and evaporates in a short time to quickly take away the heat, causing the flue gas temperature to drop rapidly and thus suppressing the production of dioxins.
The AirMin front-end atomization guns are available in a wide range of models, depending on the flow rate of 0.2-5.0 T/h, with a spray particle size of 30-200 µm and in the following materials: tungsten carbide TC, Hastelloy, 40cr.